Conway Piling manufactures their own precast piles to ensure the quality of the product to their clients.
We manufacture six different pile sizes, and they are:
We can also manufacture different pile sizes to your specification if required.
We manufacture precast concrete piles from 200mm sq to 360mm sq and in single segments from 3 mtrs to 15mtrs long. For requirements more than 15 metres, a mechanical locking joint system is then incorporated into the manufacture of such piles.
We also offer Independent pile design which is subject to approval by your engineer.
Conway Piling offer mini piling for limited access areas, areas where vibration would be an issue or areas close to existing building or within an existing building.
Our mini piles are internal bottom driven hollow steel tube mini piles.
We offer four sizes in mini piles also and they are:
This type of piling is used for a higher capacity or higher moment and lateral loadings.
H piles, these are mostly used for:
Bridge Construction Foundation
Where concrete piles might be at risk of damage, i.e., boulders.
Both these types of piles come in various sizes and lengths.
We have previously installed H piles of up to 5000kN test load requirement per pile.
Conway Piling also supplies and installs vinyl sheet piles which are an ecological, cheap and maintenance free solution to ground retention projects.
Vinyl Sheet Piles are an effective solution:
Lightweight construction of Vinyl Sheet piles can allow for easier handling therefore reducing requirement for larger machines and ease of installation in “Reduced accessible sites”.
Conway Piling also offer other piling solutions such as micro piling especially in limited access areas. These micro piles work in both compression and tension loads.
Micro piles are ideal if there is a need to tie down piles to act in tension or anchor mini pile to rock.
These come in a range of sizes.
Ideal for limited access but depending on size or capacity of pile required.
Micro piles are often used in conjunction with mini piles, for house stabilisation works, tension works etc.
Conway Piling have recently introduced Screw Piling into our product range.
Screw Piles are used to anchor foundation base to ground. These also work with both tenson and compression loads.
There is no concrete required for this type of piling.
It is ideal for limited access jobs while screw piles do come in various different sizes.